Reset of Target Signal Count in Wait Processor

[#1]

I have a flow in which I wait for 5 files to come out from each of the respective executeProcessors, after which I start another processor. I achieved this using Wait and Notify processors by target signal count given as 5. I stop and restart the flow, it works as expected. Now, my question is when and how would this counter be reset? If the executeProcessors are scheduled to run for every 30 min, do signals from notify keep increasing the counter. If so, how does my wait processor ever match the signal count of 5 that I gave and proceed to next processor every time.

Thanks,

John

[#2]

@John Carter

Would you accept the answer so that others know it resolved your issue?

[#3]

Hi Wyner, Yes, after i disabled and enabled the MapCahce service configuration, it was working fine. Thanks for that.