Community Articles

Find and share helpful community-sourced technical articles.
Labels (1)
Master Guru

# Max Timer Driven Thread Count and Max Event Driven Thread Count:


Out of the box NiFi sets the Max Timer Thread Counts relatively low to support operating on the simplest of hardware. This default setting can limit the performance of very large high volume dataflow that must perform a lot of concurrent processing.

General guidance for setting this value is 2 - 4 times the number of cores available to the hardware on which the NiFi service is running. With a NiFi cluster where each server has different hardware (not recommended), this would be set to the highest value possible based on the server with the fewest cores.

NOTE: Remember that all configurations you apply within the NIFi UI are applied to every node in a NiFi cluster. None of the settings apply as a total to the cluster itself.

NOTE: The cluster UI can be used to see how the total active threads are being used per node.

Closely monitoring system CPU usage over time on each of your cluster nodes will help you identify regular or routine spikes in usage. This information will help you identify if you can increase the “Maximum Timer Driven Thread Count” setting even higher. Just arbitrarily setting this value higher can lead to thread spending excessive time in CPU wait and not really doing any work. This can show as long tasks times reported in processors.


*** The Event Driven scheduling strategy is considered experimental and thus do not recommend that it is used at all. User should only be configuring their NiFi processors to use one of the Timer Driven scheduling strategies (Timer Driven or CRON Driven).


# Assigning Concurrent Tasks to processor components:


Concurrent task settings on processors should always start at default 1 and only be incremented slowly as needed. Assigning too many concurrent tasks to every processor can have an affect on other dataflows/processors.


Because of how the above works, it may appear to a user that they get better performance out of a processor by simply setting a high number of concurrent tasks. What they are really doing is simply stacking up more request in that large queue so the processor gets more opportunity to grab one of the available threads from the resource pool. What often happens is users with a processor only running with 1 concurrent task are affected (simply because of the size of the request queue). So that user increases their concurrent tasks. Before you know it the request queue is so large, no one is benefiting from assigning additional concurrent tasks.


In addition you may have processors that inherently have long running tasks. Assigning these processors lots of concurrent tasks can mean a substantial chunk of that thread pool is being used for an extended amount of time. This then limits the number of available threads from the pool that are trying to work through the remaining tasks in the queue.

Take a Tour of the Community
Don't have an account?
Your experience may be limited. Sign in to explore more.
Version history
Last update:
‎09-12-2018 12:50 PM
Updated by:
Top Kudoed Authors