Outdated HAWQ tutorial?

[#1]

I downloaded the HAWQ-HDP sandbox and verified that Ambari & HAWQ are running. However, I cannot locate the commands mentioned in this tutorial--gpstart, gpstop, etc. Is this just outdated tutorial, or am I missing something obvious? Is there a better resource I should use to evaluate HAWQ?

Thank you,

Eric

[#2 · Accepted solution]

@Eric Lemmon

Hope this helps you:

http://hdb.docs.pivotal.io/20/bestpractices/HAWQBestPracticesOverview.html

[#3]

Thank you, @SBandaru. Yes, I have been looking over on Pivotal. I am assuming that these are all the updated counterparts to the gp* commands: http://hdb.docs.pivotal.io/20/reference/cli/management_tools.html

[#4]

@Eric Lemmon

What tutorial link are you using? If you are using this: http://hortonworks.com/hadoop-tutorial/getting-started-with-pivotal-hawq-on-hortonworks-sandbox/

... then note that the above mentioned tutorial was designed for HAWQ 1.3, and is not a good one to use with 2.0 since a lot has changed. While a new tutorial is being crafted, you can try a few things previously posted by @Ali Bajwa and @Zack Odom:

https://community.hortonworks.com/repos/48038/lending-club-demo.html

https://community.hortonworks.com/articles/34193/install-hdb-hawq-via-ambari-and-use-zeppelin-for-v....

Finally, yes, the link above you mentioned a good place to start for using basic HAWQ commands, many of the commands are available via Ambari as well.