Created 06-08-2018 03:27 PM
Hello,
I am new to security setting and we can setup knox as gateway and it will prevent some of the security risks. If we enable Knox where we need to configure edge node? Knox suppose to be front of edge node and any command we execute in edge node go through knox? How we suppose to design edgenode and knox togerther?
thank you
Created on 06-08-2018 10:19 PM - edited 08-17-2019 07:55 PM
I can understand the confusion that's brewing in your mind. In a kerberized production cluster, you'd usually have Edge node, Master and slave nodes. I will not go in the description and placement of every single component but the below distribution gives you a picture.
Note: The worker node usually MUST have at least 2 slave processes Datanode & NodeManager, all the client software goes on the Edge node and the Master node holds the other components notably NameNode,RM,Zookeeper HA's etc
Master (3x)
Slave(worker nodes) n
Below on the knowGateway is installed all the client software, the Hadoop services here represent the Master and Slaves nodes.
The Knox gateway should sit on the Edge node as should be the only access to the cluster as illustrated above.
HTH
Created 06-08-2018 06:00 PM
@Anpan K Yes, Knox should be accessible to external users, so it has to be installed on node which can be access from outside the cluster. Like an edge node. This node can be still be managed by ambari.
HTH
Created on 06-08-2018 10:19 PM - edited 08-17-2019 07:55 PM
I can understand the confusion that's brewing in your mind. In a kerberized production cluster, you'd usually have Edge node, Master and slave nodes. I will not go in the description and placement of every single component but the below distribution gives you a picture.
Note: The worker node usually MUST have at least 2 slave processes Datanode & NodeManager, all the client software goes on the Edge node and the Master node holds the other components notably NameNode,RM,Zookeeper HA's etc
Master (3x)
Slave(worker nodes) n
Below on the knowGateway is installed all the client software, the Hadoop services here represent the Master and Slaves nodes.
The Knox gateway should sit on the Edge node as should be the only access to the cluster as illustrated above.
HTH
Created 08-16-2018 10:08 AM
best article I have read on this blog. worth to read it thank you
Created 06-10-2018 10:54 AM
Any updates?
If you found this answer addressed your question, please take a moment to log in and click the "Accept" link on the answer.
Created 06-11-2018 05:52 AM
Edge nodes are the interface between the Hardtop group and the outside system. Thus they're some of the time alluded to as entryway nodes. Most normally edge nodes are utilized to run customer applications and group organization apparatuses.