Support Questions
Find answers, ask questions, and share your expertise
Announcements
Check out our newest addition to the community, the Cloudera Innovation Accelerator group hub.

Outdated HAWQ tutorial?

New Contributor

I downloaded the HAWQ-HDP sandbox and verified that Ambari & HAWQ are running. However, I cannot locate the commands mentioned in this tutorial--gpstart, gpstop, etc. Is this just outdated tutorial, or am I missing something obvious? Is there a better resource I should use to evaluate HAWQ?

Thank you,

Eric

1 ACCEPTED SOLUTION

3 REPLIES 3

New Contributor

Thank you, @SBandaru. Yes, I have been looking over on Pivotal. I am assuming that these are all the updated counterparts to the gp* commands: http://hdb.docs.pivotal.io/20/reference/cli/management_tools.html

Contributor
@Eric Lemmon

What tutorial link are you using? If you are using this: http://hortonworks.com/hadoop-tutorial/getting-started-with-pivotal-hawq-on-hortonworks-sandbox/

... then note that the above mentioned tutorial was designed for HAWQ 1.3, and is not a good one to use with 2.0 since a lot has changed. While a new tutorial is being crafted, you can try a few things previously posted by @Ali Bajwa and @Zack Odom:

https://community.hortonworks.com/repos/48038/lending-club-demo.html

https://community.hortonworks.com/articles/34193/install-hdb-hawq-via-ambari-and-use-zeppelin-for-v....

Finally, yes, the link above you mentioned a good place to start for using basic HAWQ commands, many of the commands are available via Ambari as well.