yum install error- please help me out!

[#1]

It was working fine past few days. And all of a sudden I am getting following error for any yum command.

http://dev2.hortonworks.com.s3.amazonaws.com/repo/dev/master/utils/repodata/repo md.xml: [Errno 14] PYCURL ERROR 22 - "The requested URL returned error: 403 Forb idden" Trying other mirror. To address this issue please refer to the below knowledge base article https://access.redhat.com/solutions/69319 If above article doesn't help to resolve this issue please open a ticket with Re d Hat Support. Error: Cannot retrieve repository metadata (repomd.xml) for repository: sandbox. Please verify its path and try again

[#2]

Hi @Karpagalakshmi Rajagopalan

Where are you getting this error from ?

Are you following any instructions or tutorial that's leading to this error ?

Can you please point us to that doc ?

[#3]

Hi Raja,

I am getting this error while trying to setup RStudio . I am using the following tutorial.

https://community.hortonworks.com/content/kbentry/69424/setting-up-rstudio-on-hortonworks-docker-san...

In particular, while trying to install Rstudio in the first step. Later I found that I get the same error for all yum commands.

[#4 · Accepted solution]

@Karpagalakshmi Rajagopalan

As you are getting the following error :

http://dev2.hortonworks.com.s3.amazonaws.com/repo/dev/master/utils/repodata/repo md.xml: [Errno 14] PYCURL ERROR 22 - "The requested URL returned error: 403 Forb idden" Trying other mirror. 

You should set the "enabled=0" (this will disable the sandbox.repo) which has issue. As that is just development repo and might not be available always.

# cat /etc/yum.repos.d/sandbox.repo
[sandbox]
baseurl=http://dev2.hortonworks.com.s3.amazonaws.com/repo/dev/master/utils/
name=Sandbox repository (tutorials)
gpgcheck=0
enabled=0

.

After making the above change please do a yum clean all as following and then everything should be fine.

# yum clean all

.

[#5]

@Karpagalakshmi Rajagopalan

Good to know that the issue is resolved and solution worked for you. It will be also great if you can mark this HCC thread as Answered by clicking on the "Accept" Button. That way other HCC users can quickly find the solution when they encounter the same issue.

[#6]

sure will do that

[#7]

try mv /etc/yum.repos.d/sandbox.repo /tmp

do your yum install and move the sandbox.repo back to /etc/yum.repos.d

[#8]

Hi Jay,

Your solution worked! Thanks very much for your help.

[#9]

How did you do "Enable=0" ?

please describe.