About jpconver2

jpconver2 · ‎05-21-2024

Thanks a lot for the information RAGHUY and MathWho for the comments. I will accept the solution. We have a lot of integrations built on nifi 1.X so I think we will try to find a way to overcome the problem at least for our versions and then migrate to 2.X when possible. Thanks again!!

jpconver2 · ‎01-13-2023

Dear community, We have a NiFi cluster installation of 3 nodes, and we need to call on an API that demands to be called, at most, once every 5 seconds. We found the ControlRate processor which seems exactly what we need, but at our 3 nodes installation ends up doing 3 calls every 5 seconds. Is ControlRate only meant to be used on a single node installation, or on flows that start from a processor set to Primary Only? Is there any way to use ControlRate in a multi node installation, or any combination of processors that would allow us to get that result? We are running NiFi 1.7.1 but if there is any solution in a newer NiFi we may be able to backport it. Thanks a lot for any advice on this. Best Regards!! JP

jpconver2 · ‎11-16-2020

Thanks a lot for your answer!!

Online	Offline
Last Visited	‎05-21-2024 11:12 AM

Member Since	‎08-14-2018 08:15 PM
Last Visited	‎05-21-2024 11:12 AM
Posts	8
Kudos received	1

Cloudera Community

Re: Nifi Rolling Update Strategy in Kubernetes (to...

Rate limit in a clusterized NiFi installation

Re: NiFi cluster processor count scalability